How To Make Moccasins That Cuddle Your Feet

Moccasins can be beaded like these Cheyenne ones ~

Cheyenne moccasins
Cheyenne moccasins | Source

Keep your toes warm this winter ~

If you know how to make moccasins that cuddle your feet and and keep your toes warm this winter, you can make some wonderful gifts for loved ones or friends.

Native American peoples have always been very creative and ingenious. They used every scrap of hide for clothes, bags, pouches, robes, and moccasins. For warm and comfortable winter footwear there is nothing better than a pair of soft soled moccasins. I am going to show you how to make moccasins that cuddle your feet and keep your toes warm this winter. It really is not as difficult as one may think.

Let's take a look at some basic steps to make moccasins and the supplies you will need. It really is not as difficult as one may think.

Supplies and tools needed ~

  • Deer, Elk, or moose hide (at least 2 square feet) - These hides are softer and stretchier than cowhide or pig suede. Deer hide is thinner than moose and elk, so it is easier to stitch and gather.
  • Artificial Sinew
  • Leather Needle (Glover's Needle)
  • Paper bag for pattern
  • Pen or Soft Lead Pencil
  • Scissors
  • Leather thumb guard (for ease in pushing the needle through the hide)

Sewing Tips ~

Caution: Glover's needles are very sharp. They have a three sided point that cuts on all three sides. This enables the needle to pass through the leather without tearing. Be very careful when using these needles. Wear a leather thumb guard to help push the needle through the leather.

Use an overcast or whip stitch and sew by hand. Make a knot at the beginning and ending of each seam, keeping the knot on the outside of the moccasin for comfort.

Make your pattern ~

To make the pattern, place one foot on paper and draw around the foot in the design shown in Diagram 1. Extend by a half an inch beyond toes and heel of foot. Make sure the sides on either side of the pattern will come far enough up and over the top of the foot and leave a half inch seam allowance.

The straight edges on the side that extend out further determine the cuff size which will be folded down. If you like, you can extend this cuff to go up as high as the knee, or just below the knee, if you want "high tops".

Diagram 1

Pattern for center seam moccasin
Pattern for center seam moccasin | Source

Checking and cutting the leather ~

Carefully check for holes or markings on the hide before marking your pattern.

Since leather is a natural material each piece will vary in the stretch. The stretchiest part should go across the foot rather than from toe to heel. Do not try to pin the pattern to the hide, for two reasons: it is too difficult to do and pinning might distort the pattern. There will be a rough side and smooth side to the hide. Decide which side you want inside next to your feet.

Place the pattern on the wrong side of leather (the side that will be the inside of your moccasin) and very carefully draw around the pattern onto the leather with a pen or soft lead pencil. Cut pattern out. It is important to cut only one thickness at a time so the pattern remains true.

Deer hide ~

Deer pelt before fur is removed in tanning process.
Deer pelt before fur is removed in tanning process. | Source

Sewing ~

For a smoother look, hide the stitching inside the moccasin by sewing it inside out. Sinew is the traditional "thread" to use for sewing items made from hide. You can purchase artificial sinew, which is just as strong and cheaper. Remember to keep the knots on all seams on the outside so as not to irritate the tender footsie inside.

Using a whip stitch (see diagram 2) and beginning at toe, stitch up to the ankle in front. When this seam is finished do not cut off the sinew, make a stitch or two to secure the seam and then go back down the seam to make a narrow welt along the length of the seam by turning down the seam salvage and stitching it in place. This will make the moccasin stronger and will also help to prevent the seam from showing on the outside. It is okay if the toe is puckered like a rabbit's nose -- this is often seen on moccasins and is rather cute. Any other puckered spots on the outside can be pounded flat with a wood mallet.

Sew up the back seam from heel to top. A heel tab can be added with a whip stitch if desired. In the days of the ancient ones, heel tabs sewn on the moccasins dragged along the ground and covered tracks. This tab can be fringed, trimmed in points, or left straight. See diagram 3 for detail.


Diagram 2 , Whip stitch ~

Whip stitch
Whip stitch | Source

Finishing ~

Turn moccasin inside out. Now you know it is going to fit nicely, because you used your own foot for the pattern. However, if you just cannot wait. You must be very excited to have gotten this far, so go ahead and try it on just for fun.

To secure the moccasin on the foot, a thong is made to wrap around the ankle. The best way to make a thong is to cut it from a scrap of hide in a spiral from the outside towards the center. Measure your ankle and add the inches needed to wrap from back to front and tie in the back of the ankle. This is the length you will need for the thong on each moccasin. Secure the thong in the back of the moccasin by making three loops in the hide with the sinew and sliding the thong through these loops. (see diagram 3) The cuff can be turned down after tying the thong.

If you have made high top moccasins, these can be secured while wearing by tying a longer thong around the ankle then criss-cross in back and front alternately until you are about two inches from the top, then tie in front. To prevent cutting off circulation to foot or leg, do not wrap and tie this thong too tightly.

Diagram 3

Finished moc showing heel tab and thong around ankle.
Finished moc showing heel tab and thong around ankle. | Source

Still enthusiastic and feeling creative?

Moccasins are often beaded in beautiful designs. If you are a beader, you may want to decorate your moccasins in your own unique design. Or trying a traditional design and color scheme from a particular tribe gives an authentic and traditional look to your moccasins. Usually only the top is beaded. The part of the cuff that will be turned down can be beaded also.

Fringe can be added around the ankle. When the cuff is turned down, the short fringe is quite attractive and authentic looking. A strip of beading at the top of the fringe gives a very nice finished edge.

A lining of rabbit fur or imitation fur can be made by using the same pattern used for the moccasin. Just make the seam on the non-fur side and make sure knots are on the same side. Turn lining fur side in and slip it into the moccasin. Secure to moccasin by tacking (small stitches) around the ankle and take a few stitches at the toe and heel. Your foot will love being cuddled by this fur.
~ ~ ~ ~

No time or inclination to make your own moccasins? Check out these beauties.

These will take a little more attention, but well worth it ~

Note from author ~

Enjoy wearing your cozy moccasins around the house. Heed a warning, though -- a lot of people may ask you to make a pair for them. They will make great gifts.

Thank you for reading my article. Your opinions are important to me and let me know your interests. This helps me to offer more of your favorite subjects to read about. Your time and interest are very much appreciated. I hope to hear from you in the comments section below.

I write on several different subjects, all evergreen articles. You can read more about me and see more articles I wrote by clicking on my name by the small picture of me at the top right of this page.

Blessings and may you always walk in peace and harmony, softly upon Mother Earth.

Phyllis Doyle Burns - Lantern Carrier, Spiritual Mentor
~ ~ ~ ~

© 2010 Phyllis Doyle Burns

More by this Author


Comments 12 comments

Stacie L profile image

Stacie L 6 years ago

a very informative hub indeed! nice work..


Phyllis Doyle profile image

Phyllis Doyle 6 years ago from High desert of Nevada. Author

Thank you, Stacie. I make these moccasins for my cloth dolls and they look so cute. My dolls are only nine inches tall, so the mocs are very small. I made a pair for myself and they are very comfy for indoor wear.


WillStarr profile image

WillStarr 5 years ago from Phoenix, Arizona

What a great article! I love moccasins and now I can make my own.

Thanks Phyllis!


Phyllis Doyle profile image

Phyllis Doyle 5 years ago from High desert of Nevada. Author

You are welcome, WillStarr. Let me know how they turn out. I love mine.


Song-Bird profile image

Song-Bird 5 years ago from Michigan

I never thought of doing this but now I am going to try it! My husband is a deer hunter and I am a crafter - a perfect combination for this project :) Thanks for the great hub!


Phyllis Doyle profile image

Phyllis Doyle 5 years ago from High desert of Nevada. Author

Song-Bird, thank you for stopping by. I am sorry it took so long to get back to you, I have been away for awhile.

You certainly do have a perfect combination there for making moccasins -- a deer hunter and a crafter! Do you tan your own hides? I have never tanned hides myself. I pick up hide scraps at stores like Tandem Leather or online.


Dolores Monet profile image

Dolores Monet 5 years ago from East Coast, United States

Voted up and so very cool! If it's okay, I want to link this hub to my yet unpublished hub on the history of shoes. A friend of mine made me hand made slippers one Christmas, out of felted wool. They are the most comfortable footwear I own.


Phyllis Doyle profile image

Phyllis Doyle 5 years ago from High desert of Nevada. Author

Thank you, Dolores. Of course it is ok for the link, thank you for that also. I bet you slippers are comfy. Did your friend bead them? I use this moc pattern for my little Native American dolls. They are so small I can make a pair in an hour or less.


Jeepurrr 2 years ago

Hi Phyllis. Thank you for instructions I can understand. My daughter showed me how to make dream catchers from the birds and rabbits I harvest and I really enjoy giving them away as gifts. I am one of those guys that uses the whole animal. I am looking forward to deer season this year and with any luck elk. I can't wait to make my own pair of moccasins and start making them for my friends and family. Thank you again and I'll keep in touch just in case I need an extra pointer or two:)


Phyllis Doyle profile image

Phyllis Doyle 2 years ago from High desert of Nevada. Author

Hi Jeepurrr, you are most welcome and thank you for the visit and interesting comment. Your daughter must be very talented. I love making dream catchers -- not only is it fun, but very relaxing for me. Today I gathered some thin red branches from some bushes near by. I will braid the flexible branches then shape them into a circle to use for dream catchers. So, do you prepare the sinew from the animals yourself? I know how to do it, but have never tried it. I use artificial sinew and bees wax to keep it from fraying. Please do keep in touch. I would like to know how your moccasins turn out. Thank you again. Good luck when deer season comes around.


Sammi 2 years ago

I love this pattern and step by step tutorial. I am currently raising meat rabbits and plan on tanning the hides. Would a tanned rabbit fur be suitable for this type of project?


Phyllis Doyle profile image

Phyllis Doyle 2 years ago from High desert of Nevada. Author

Hi Sammi. You can use the treated rabbit pelt with fur still attached for trim around the ankle or to line the moccasin inside with the fur extending up and around the ankle.

    Sign in or sign up and post using a HubPages Network account.

    0 of 8192 characters used
    Post Comment

    No HTML is allowed in comments, but URLs will be hyperlinked. Comments are not for promoting your articles or other sites.


    Phyllis Doyle profile image

    Phyllis Doyle Burns (Phyllis Doyle)738 Followers
    134 Articles

    Phyllis is a very crafty lady. She makes dolls, doll clothes, moccasins, dreamcatchers, and loves to bead in Native American style.



    Click to Rate This Article
    working