How to Remove Airbag Decals From Sun Visors DIY WV/AUDI
DIY For Removing Decals From Sun Visor
This is probably one of the easiest, fastest and cheapest DIY's to do that really does add a whole new look to your car. It is such a small part of your car that it is often overlooked, but once removed it makes the headliner and visors flow together.
This DIY is a charm for that reason. Even people that have the same exact car will ask you why yours looks better. I think it's a subliminal thing of always having that bright colored warning in your face, you learn to ignore it and once it's gone you don't realize it. Others just see that something looks better and most can't figure out what it is!! Snap into a slim jim Ohhh Yeaaahh.
Tools For The Job
As with any of my DIY's you need some tools. With this diy your tools are simple products that can be found under your sink or at the grocery store for a couple of dollars.
- Paper Towels
- Rubbing Alcohol
If you did my maf clean diy you already have the isopropyl alcohol and for the paper towels, well, just steal them from your mom's house.
Removing the Decals
- Fold up a paper towel to the size of the decal and completely blot the towel with rubbing alcohol.
- Hold the paper towel against the decal for about two minutes.
- Sometimes you can pull the paper towel and the whole decal will come off with it, if not then rub the airbag decal inward till you can pinch it all off. Don't rub it in all directions or you will have little sticky white pieces stuck to your visor. If anything does stick just hold a fresh alcohol soaked paper towel to it.
- After the decal is removed you will still see (in proper light) the indentation of the sticker. This applies more to older cars with black sun visors.
- Rub the whole visor down with rubbing alcohol to make sure none of the decal glue is left.
- Use a good interior wipe/spray and clean them off, after a few cleanings you should no longer see the indentations of the decals.
More VW/AUDI DIY's
- How to cut down Shift Rod DIY
- Fuel filter DIY
- How To Fix Broken Wire Harness Clips
- How To Replace Tie-Rod VW/Audi
- How To Clean Throttle Body 1.8t VW/Audi
- Fix Broken Rear Seat Latch GTI
- Replacing Spark Plugs & Coils 1.8t VW/Audi
- How To Replace Climate Control Bulb VW/Audi
- Replacing the Temperature Sensor 1.8t VW
- How to Remove & Replace Intake Manifold Gasket 1.8t VW
- How to clean or Replace MAF Sensor VW/Audi
- Boost Gauge Install for MKIV 1.8T
More by this Author
How to fix or replace broken wire harness clips or plugs on all VW and Audi cars: 1.8T Jetta, GTI, Golf MK4, and Audi B5 and B6. You can use a special tool or a paper clip!
Volkswagen DIY on changing out your Coolant temperature sensor that can lead to rough idol and a number of other problems. This diy works for Audi and VW across the board depending on year the common part is...
DIY for Jetta, Golf, GTI, Passat, New Beetle, A4 on cleaning or replacing the MAF (mass air flow) sensor. Step-by-step pictures, part numbers, and tools required for the job.
No comments yet.