ASME Standards for the Revision of Engineering Drawings

ASME has issued standards for the proper documentation of drawing revisions.
ASME has issued standards for the proper documentation of drawing revisions. | Source

Overview

American Society of Mechanical Engineers standard ASME Y14.35M was issued in 1997 to describe the ASME approved format for tracking revisions and other changes to engineering drawings. ASME Y14.35M was reaffirmed in 2003, and no changes were made at that time.

What does ASME Std Y14.35M mandate?

ASME Y14.35M Standard

ASME Y14.35M allows for changes to be made to drawings by adding and crossing out information on a drawing or by creating a new drawing revision.

The ASME drawing standards state that new drawings can be recorded as a new revision letter or as a new drawing number that supersedes the old one. The replaced drawing will be modified to note “replaced with change by drawing 1234567”. This ensures configuration management and product verification is handled correctly.

The first version of a drawing is identified by a revision dash “-“. After that, revision letters are used. Revision letters can be a single letter up to multiple letters.

All letters can be used as revision letters except I, O, Q, S, X and Z. These letters are not allowed because they can be mistaken for numbers or for other letters. For example, a revision letter I can be mistaken for a 1 while an S can be mistaken for a 5. Revision letters must also be uppercase, to minimize confusion between a lowercase "l" and "1" and "I".

After the end of the revision letter sequence is used up, the next letter is added to the end. Revision letter Y is followed by revision AA. Revision AY is followed by BA. Revision DY is followed EA.

However, revision letters are not allowed to exceed two characters, so there is no revision greater than YY. At this point, you should issue a new drawing number.

Revision columns are located in the upper right corner or next to drawing the title block. Revision columns include the revision letter of the drawing, a short description of the changes made between this revision and the prior one, and the date the revision was made or the revised drawing was approved. Revision columns frequently include the drafter who made the latest revisions.

ASME standards require parts to be labeled with the part number and revision letter per their manufacturing drawings.
ASME standards require parts to be labeled with the part number and revision letter per their manufacturing drawings. | Source

Related Standards

ASME standard Y14.24 gives readers a list of when ASME engineering drawing standards like ASME Y14.35M apply. ASME Y14.1 defines the acceptable form of the revision history block.

ASME Y14.1 gives the ASME standard size and format used in engineering drawings.

ASME Y14.2M outlines the accepted line conventions and lettering used on engineering drawings. ASME Y14.3M describes the accepted forms of single, multiple and sectional views used on engineering drawings.

ASME Y14.100 provides a list of standard engineering drawing practices recommended by the ASME.

More by this Author


Comments 1 comment

Steel Engineer profile image

Steel Engineer 2 years ago from Kiev, Ukraine

Worthwhile read. Thanks for sharing this.

    0 of 8192 characters used
    Post Comment

    No HTML is allowed in comments, but URLs will be hyperlinked. Comments are not for promoting your articles or other sites.


    Click to Rate This Article
    working