Self Priming Unit for Centrifugal Pumps
Centrifugal pumps are not self priming. If initially there is no liquid a the eye, there will be no pumping action for a centrifugal pump. In absence of liquid, air (sometimes vapour) will be present at the eye, and owing to its light density air could be thrown out under centrifugal force only if the speed of the impeller is very very high (like in a Turbocharger Blower). In such a case, where normally a the start of the pump the level of the liquid is below the eye of the impeller, we can make use of a self priming unit.
Figure above shows an automatic arrangement for pumping out bilges, using a centrifugal pump, wherein the air (vane) pump will get engaged automatically and draw out any air at the start or during running. Once the air is drawn out it will get disengaged automatically.
Discharge side of the pump is connected with one side of the piston (engage / disengage mechanism) as shown in the figure. Consider the pump is started with no liquid at the eye of the impeller. Now the impeller will be rotating but the absence of liquid at the discharge (means no discharge pressure) makes the piston to move forward due to spring pressure and thus the bevel connected to the air pump rotor shaft engages with the rotating shaft of the centrifugal pump. This drives the air pump to remove any vapour or air present inside the pump suction and the liquid rises to prime the pump. Once the pump is primed discharge commences, discharge pressure rises which acts on the piston thereby pushing the piston against the spring pressure. Thus the air pump gets disengaged. Hence whenever there is any ingress of air or vapour in the pump suction, discharge pressure reduces and air pump engages to remove the same.
"Basic Marine Engineering" by J.K.DHAR
More by this Author
It sometimes necessary to obtain an approximation to the power of the ship without restoring to model experiments, and several methods are available. One system which has been in use for several years is the admiralty...
Shell and Tube, Plate Heat Exchangers Advantages Simple and Compact in size Heat transfer efficiency is more Can be easily cleaned No extra space is required for dismantling Capacity can be increased by...
Linear resistors are those in which current produced is directly proportional to the applied voltage. Their current versus applied voltage is straight and linear. In other words, their resistance remains constant. ...