Well, it's not. ;) Embossers create a shiny raised 3D-like stamp pattern. They are great for card making and scrapbooking. An embosser is basically a hair dryer that is used in stamping. I recently bought one to use when making the invitations to our daughters's birthday party.

Here's what you need:

1. An embossing heat tool- I bought the Marvy embosser at Paper Source for $22.00, but now I know you can get them a lot cheaper on eBay.
2. A rubber stamp - any size or shape you choose.
3. A rubber stamp ink pad-any color you like. You don't need special embossing ink pads.
4. Embossing powder-clear powder shows the color of your ink or you can choose a powder color that will override the ink color. A small container goes a long way.

1. Saturate stamp in ink pad. The best way to do this is hold the stamp in one hand and blot the ink pad on the stamp. It works better than pressing the stamp down on the pad.
2. Place the stamp on the desired location gently, then push down in the middle of the stamp. Try not to rock back and forth with the stamp.

3. Remove stamp from surface and generously apply embossing powder so all of the stamp ink is covered. Gently shake excess powder back into powder container.
4. Turn on embosser and wait until the air is hot. Be careful, it gets really hot. Slowly heat the stamp ink and powder pointing the embosser at a 45 degree angle. You will notice the stamp becoming raised and shiny. Be sure not to heat the stamp for too long. Practice a few times on a scratch piece of paper before your final product.
5. Voila, you have an embossed stamp. I know you're itching to go get one now! ;)