ge profile dishwasher

61
rate this page

By fyxer


The most common problems i find with the ge profile dishwasher is not draining properly, after the cycle is complete there is a noticable amount of water left at the bottom of the dishwasher.

This is usually caused by a defected piston nut, the piston nut is a little plastic mechanism that open and close to let water go in different directions dependind on how much water is in the dishwasher, it is located inside the dishwasher at the back behind the lint filter.

The computer control, like all other computer controls go bad sometimes, if all the lights on the control lit up and it will not operate on any cycles that you try to set it on, this usually mean the control is defective.

  • Please specify a query! (9003)




No Amazon results found

<script src="http://www.google-analytics.com/urchin.js" type="text/javascript">

</script>

<script type="text/javascript">

_uacct = "UA-2502005-1";

urchinTracker();

</script>

detergent cup
detergent cup
control board
control board
water valve
water valve
  • Whirlpool Polara Refrigerated Range

    This is a stove that has the capability to also be used as a refrigerator, this stove was introduced about 6 years ago. The idea behind this stove is that it gives the owner the options to take the chicken out of the refrigerator and place it into the oven where it can be kept cool for several hours. With the stove set to the cooling mode cooking can be set to start at a later time. 2 months ago

  • Clothes Dryer

    There are two types of clothes dryers one is gas the other is electric. The gas dryer is half gas and half electric, the gas is used for lighting a flame to create the heat to dry the clothes, the electric is used to operate the motor, timer, ignitor, coil kit and thermostats. 2 months ago

  • Whirlpool Washing Machine - Don't Wash or Spin

    Washing machines made by Whirlpool, Sears, Kenmore and Kitchen Aid, these newer machines are called direct drive, the older machines used a belt and motor to drive the transmission. These direct drive machines use a coupling to drive the gearcase, this coupling is connected to the motor and the gearcase, the couplings sometimes break. When this happens the machine will take in water and drain as this does not affect the pump, when the coupler breaks, the machine will not wash or spin because the motor is not connected to the gearcase, at the end of the cycle you will find that the clothes are wet but not washed. 2 months ago

  —   Rate it:  up  down  [flag this hub]

working