thank you Lowes. I made this bong 100% from Lowe's home improvement material. I got all the pieces from the plumbing department, and I was very reluctant to have a associate in that department help me. I told most for my potato gun, which I guess could have worked. I used a total of 10 pieces all of which are PVC piping. With the exception of the bowl.

I started out by using a 1 foot PVC pipe which was about 2 inches in diameter, and a threads on the ends. Then I connected it with the nozzle which can open and close, and connect the nozzle to a 4 inch PVC with threads on it as well.then I connected the four-inch PVC to a T connector, followed by two and caps that screwed on. All these PVCs have threads on them.


All right now screw all six pieces together to get the shape of the bong. This is what the bong will look like will.

Already, you'll also have to purchase some primer for PVC and PVC adhesive. once you purchase the primer and adhesive, go ahead and prime the 2 endcaps that connect to the tee on the bottom of the bong as well as 4 inch Piping that connects the T. after their primeed go ahead and apply the glue or adhesive, and screw on the PVC and connect them. Now you will need to find a small three or 4 inch metal straw with threads on the end and a small little bowl where you can apply a screen. Now you will need to drill a hole about halfway down the 4 inch PVC piping, and try to do it at an angle so the bowel will be facing at an upward angle. Once you have it in and it is at an angle, apply some sort of clue (preferably gorilla glue) around the metal straw that is going into the four-inch PVC so no water can get out of the hole or the gap. And make sure it dries at an upward angle. This will take a couple hours for the glue to dry. Now look around the plumbing and look for a cone shaped piece of rubber that can be used as The mouthpiece at the top of the 1 foot PVC. This will also be found in plumbing. This piece of rubber cone fits snugly on top of a 1 foot PVC and is a great place to put your mouth when inhaling..

Once everything is dry, and it looks all good to go, fill the bong with water up to the beginning of the bottom of the nozzle. So basically fill it with water all the way up to the very top of the 4 inch PVC. That way when you close the nozzle and turned upside down no water will escape. The trick to the nozzle is, they like the product on fire in the bowl and inhale, and are just about done with that hit, close the nozzle and inhale everything that is last in the 1 foot PVC to clear the bong. This will finish you off well.

Things to watch out for
make sure use proper PVC sealant. If not this may cause the bong to leak at the bottom of the T. also you want to be sure that the bowl is at an upward angle and is also sealed off tightly to the PVC with glue. This will prevent all leaks.

Go ahead and enjoy this product that you just made what a beauty.
I highly recommend that this is used for tobacco products. But what you do is none of my concern. Just please enjoy and have fun.

Any questions or comments, or even suggestions on how to improve this item please leave comments at the bottom as well as your ideas. Thank you.