- Family and Parenting»
- Babies & Baby Care
How to Keep Disposable Diapers from Leaking at Night
Surprise! Disposable diapers leak!
When I adopted my infant son, I was under the naïve impression that diapers marked "leakproof" were actually leakproof. All was good for the first three weeks... until my little baby boy began sucking down as much formula (and therefore, peeing) as much as a 4 month old. The doctor was surprised but told me all was good with the baby's health and that I shouldn't worry.
I didn't, except that apparently, 4-month-old babies' volume of pee does not fit into a newborn-sized diaper. As soon as Little Man began sleeping more than 2 hours in a row, I'd find him covered in baby pee up to his chin. Every feeding required a full wardrobe change, which, when poor mommy is sleep deprived and it's the middle of the night, is not an attractive feature in a baby.
I scoured the internet for ideas and found a few good ones. I also came up with my own. All four methods are written below. Hopefully, one will work for you!
My Method: Making Double Diapers
The method I made up (in my sleep deprived state) involves two different diaper sizes. You will need:
- a small diaper (either one your child wears now, or an outgrown size)
- a diaper a size larger than your child wears or one still a bit big
- a pair of scissors
- if you have it, double stick tape (not necessary, but makes life easier)
Steps to my Method
(Edit: Since writing this article, I no longer cut the edges off the little diaper... I just turn the it inside out and tuck in all the "frilly" edges and tapes. This made for a lot less work!)
- Take the scissors and the smaller diaper. Carefully trim off the side edges and elastic portion of the diaper. Discard the scraps.
- Decide where your leaks are coming from. My boy is a stomach sleeper. This means his front gets all wet. If you have a back sleeper, you may have to proceed differently.
- For a tummy sleeper (my doc said it was ok... quit being judgy!), fold the cut diaper piece in half with the absorbent part out. Stick this in the front half of the larger diaper, right under the waistband as shown. Make sure the folded part of the smaller diaper is at the top. This will bring any excess moisture toward the back of the fold You may choose to use the double-stick tape on the bottom to keep it in place (this is good for night changings, when you can't figure out what in the world is going on).
- For a girl baby who changes positions, center the strip of diaper and fold just a small section back at the front and the back of the diaper.
- For a child who wets out of the back of the diaper, move the strip back and fold a small section of the strip backwards.
Folding the strip of diaper helps redirect the wetness to the bigger diaper after the first is full. Make sure to put the smaller diaper strip so that it is under the waistband of the larger diaper.
Diaper boosters / doublers
Although you can't find these easily in stores, you can find diaper boosters / doublers online fairly quickly. To the side are a few different kinds you can use. These are self-stick pads that can be placed inside a diaper in different positions. They do not have a backing, so once they become full, moisture is automatically redirected into the actual diaper.
Suggestions for use include folding (as mentioned in the diaper strip instructions above) for front sleepers.
Two other ideas
- Double diaper. Use a smaller diaper, fasten it, and then cover it with a larger-sized diaper. I have not tried this method, but it works for some people.
- Use one diaper size larger than you normally would. For some babies, this is all it takes.