Fluke Fishing in Southern New Jersey
Location, Location, Location
Fluke, also called summer flounder are a unique fish found along the East Coast and Southern New Jersey's ocean and back bays. The fishing techniques we will be discussing will concentrate on these areas and have worked for years in targeting these tricky and tasty fish.
Fluke are a flatfish with both of its eyes located on the top of its body, this is well suited for its ambush style of hunting. Fluke lie in wait flat on the bottom of the ocean or back bays, waiting patiently for its prey to swim over, then, in a burst of speed, the fluke strikes out and drags its meal to the bottom to eat. Hopefully, after reading this hub, that meal will be your bait or lure attached to your fishing line! When targeting these fish in the back bays, location is very important.
Summer Founder season in New Jersey begins 5/7/2012 and ends 9/25/2012 you can keep 8 fish 18" min. Check with other states along the East Coast for their respective regulations as fluke are highly regulated.
Fluke like to stay cool, not hot, not cold, cool. This is accomplished by hunting in shallow warmer water "sometimes called flats", early in the spring when the water is cold and heading to deeper cooler water during the summer as the water warms. Remember these location tips to put yourself where the fish are to be successful.
To get to these locations, your are going to need a boat. Fishing boats range from many lengths and styles and we would need another Hub to discuss these so I will just use my boat as an example of back water fishing boats. I use a 17' center console with a 85 HP Suzuki outboard for my backwater fluking trips. Two people on a boat this size is perfect. A boat with a shallow draft and enough room for two to three people is plenty for back bay fluking, somewhere in the range of 17' to 20' should be sufficient. A T-Top or Bimini Top is a must for long excursions on hot, sunny, summer days. If you plan on filling up that cooler with an all day trip, you gotta have shade. I like to bring a cooler for drinks and lunch and I have a livewell on board to hold the days catch.
Boating in the Back Bays
Tackle, Lures, and Bait.
In this section we will discuss the tackle, lures and the bait used when fluke fishing. To start you'll need a medium action rod, 6'-7', a spinning or casting reel that is matched to the size rod you are using, spooled with 20lb. braid of your choice. I like to use a fluorocarbon leader and rigs made from 20lb. fluorocarbon. The most popular fluke lures are buck tails. There are hundreds of color combinations but the most common seem to be: white "my favorite", pink, chartreuse, and yellow. 3/4 to 1 oz. should be heavy enough in the back bays and waterways. I tip the bucktail with strips of squid, mackerel or sometimes flounder belly strips 3"-5" long. I have used minnows or frozen spearing as well, I like to try a combo of these different baits and mix it up to see what works best. Another style of fishing for fluke is with bait. When fishing with bait, I employ a rig made from a three way swivel, a sinker or bucktail and a size #1 or #2 snelled fluke hook (see image). Baiting this rig is similar to the bucktail. I like using live minnow and squid or frozen spearing and squid. Both seem to work pretty good when fishing for fluke. I like to buy whole squid, defrost it and cut it into strips myself. I have used pre cut strips soaked in shedder oil purchased at the bait shops and have good success with this as well. When purchasing frozen spearing, try to find the largest spearing you can "big bait=big fish". Normally I purchase my minnows the morning of the trip. Bring a minnow bucket to transport them from the tackle shop to the boat, use the minnow bucket to hold the minnows or try this tip: In a separate cooler with ice, place a rag soaked in sea water and wrung out on top of the ice and place the minnows on top of this. I think this keeps the minnows lively and they definitely last longer than tossed over the side in a minnow bucket. These are the tackle, lures and baits that I use, feel free to add suggestions to the comments section.
Tackle and Lures
Drift Sock Technique
Lets begin by talking about the boat. Most fluke fishing is done in a boat while drifting. Drifting is accomplished by shutting off the engine or disengaging the transmission and idling along and by taking into consideration the wind the current and your surroundings. I like to orient my boat sideways with the wind pushing me slightly along with the current. This is not always possible and you may encounter wind against tide conditions, or strong wind with tide or just a strong tide. If I happen to encounter one of these last two conditions I will employ what we call a drift sock. A drift sock is used for controlled drifting or is in effect an underwater parachute that when deployed slows the boats drift rate. These can be purchased for under a hundred dollars at tackle shops or one can be improvised with five gallon buckets.
When fishing for fluke with a buck tail, I like to keep my rod tip up, I keep the slack out of the line as much as possible and I jig the bait with a slight up and down motion trying to keep the lure in contact with the bottom as the boat drifts along. Some times I will jig aggressively, lifting the jig high off the bottom and letting it fall back down gently. Lastly, when fishing with bait and the rig that I talked about earlier, I will keep the rod tip up with no slack in the line and maintain constant contact with the bottom. I have noticed that when the strike occurs it will feel as if you are snagged on the bottom. When this occurs I open the bail or release a few yards of line then close the bail and when the line gets tight I will set the hook. This is called the drop back method or just dropping back. Well I hope this hub has been informative and good luck angling in the Southern New Jersey backwaters and along the East Coast.