Dryer wont heat up

  1. profile image47
    dryerinnyposted 6 years ago

    Dryer wont heat up

    I start the dryer the ignitor lights the burner ignites for about 15 seconds or so then they both go out in about a minute or so later ignitor glows the burner ignites again and this goes on and on I have replaced the gas valve heat coils and the flame sensor and it still is doing the samei have also tested the safety thermostat on a digital multmeterset at 200 oms and got a reading of 01.0 to 0.9what should I do next thanks  and the heat setting is set on high heat

  2. instantlyfamily profile image80
    instantlyfamilyposted 6 years ago

    It's possible that it is not being supplied with the proper voltage. Here are three ways to make sure power is getting to your dryer.

    First, make sure your dryer is plugged in.

    Next, check the circuit breaker panel to make sure all the circuit breakers are in the correct positions.

    Finally, check to make sure no fuses in your fuse panel are blown. Any of these could explain why power is not getting to your dryer.

    Good luck!


  3. profile image47
    dryerinnyposted 6 years ago

    ITS a gas dryer and its pluged in and the motor runs fine i thought it was a given since i stated that the burner ignites any how no help