CISCO Router's Ethernet Interface Configuration Exercise
In the Configuring an Ethernet Interface : How to Configure an Ethernet Interface of a CISCO Router,
I discussed the configuration process of a Ethernet port of a CISCO
router. After the discussion there is an exercise. The solution of that
exercise is provided in this page:
Problem Definition:
You have given a CISCO router. You have to configure base on the following specifications:
- Configure fastEthernet4/0 port
- Assign IP address (172.16.56.1/24 )
Command line of configuring a router
Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#interface fastEthernet4/0 Router(config-if)#ip address 192.16.56.1 255.255.255.0 Router(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up Router(config-if)#exit Router(config)#
If you have any difficulties of the above code then please read Configuring an Ethernet Interface : How to Configure an Ethernet Interface of a CISCO Router.
© Written by rancidTaste.