My furnace runs properly for 8-12 hours then kicks off upon ignition.
If I let it set for some hours it will work 8-12 hours again. New flame sensor already. Can I jump the red and white wire together at the thermostat or is that something to be done at the circuit board?
I have an oil furnace and it started shutting off. I would have to press the reset button to start it back up. Found out it was the blower motor going and had to replace it.
by Tina Allen198521 months ago
My ac fan is running, compressor kicks on and off, and my outside unit will sometimes do the same.My home air unit is only 5 1/2 years old. The outside fan works great. I can hear The compressor running one minute...
by Cat3 years ago
How much sleep do you consider adequate to function properly, personally?The conversation about sleeping has been popping up a lot recently. Fellow hubbers and I have been joking about the idea of never going to bed....
by Jeff Lovely6 years ago
Does paint need to have the lights on or off in order to dry and setup properly?
Copyright © 2018 HubPages Inc. and respective owners.
Other product and company names shown may be trademarks of their respective owners.
HubPages® is a registered Service Mark of HubPages, Inc.
HubPages and Hubbers (authors) may earn revenue on this page based on affiliate relationships and advertisements with partners including Amazon, Google, and others.